×

Fault tolerant control design for polytopic LPV systems. (English) Zbl 1122.93073

Summary: This paper deals with a Fault Tolerant Control (FTC) strategy for polytopic Linear Parameter Varying (LPV) systems. The main contribution consists in the design of a Static Output Feedback (SOF) dedicated to such systems in the presence of multiple actuator faults/failures. The controllers are synthesized through Linear Matrix Inequalities (LMIs) in both fault-free and faulty cases in order to preserve the system closed-loop stability. Hence, this paper provides a new sufficient (but not necessary) condition for the solvability of the stabilizing output feedback control problem. An example illustrates the effectiveness and performances of the proposed FTC method.

MSC:

93D15 Stabilization of systems by feedback
93B52 Feedback control
PDFBibTeX XMLCite
Full Text: DOI EuDML

References:

[1] Angelis G. Z. (2001): System Analysis, Modelling and Control with Polytopic Linear Models. - Ph.D. thesis, University of Eindhoven, the Netherlands.
[2] Blanke M., Kinnaert M., Lunze J. and Staroswiecki M. (2003): Diagnosis and Fault-Tolerant Control. - Berlin: Springer. · Zbl 1023.93001
[3] Bouazizi M.H., Kochbati A. and Ksouri M. (2001): H\infty control of LPV systems with dynamic output feedback. - Proc. 9th Mediterranean Conf. Control and Automation (MED’01), Dubrovnik, Croatia, (CD-ROOM).
[4] Casavola A., Famularo D. and Franzč G. (2003): Predictive control of constrained nonlinear systems via LPV linear embeddings. - Int. J. Robust Nonlin. Contr., Vol. 13, Nos. 3-4, pp. 281-294. · Zbl 1038.93027
[5] Chadli M., Maquin D., and Ragot J. (2002): An LMI formulation for output feedback stabilization in multiple model approach. - Proc. 41-st IEEE Conf. Decision and Control, Las Vegas, USA, pp. 311-316.
[6] Chilali M. and Gahinet P. (1996): H\infty design with pole placement constraints: An LMI approach. - IEEE Trans. Automat. Contr., Vol. 41, No. 3, pp. 358-367. · Zbl 0857.93048
[7] Eterno J.S., Looze D.P., Weiss J.L. and Willsky A.S. (1985): Design issues for fault-tolerant restructurable aircraft control. - Proc. 24th IEEE Conf. Decision and Control, Fort Lauderdale, USA, pp. 900-905.
[8] Geromel J.C., DeSouza C.C. and Skelton R.E. (1998): Static output feedback controllers: Stability and convexity. - IEEE Trans. Automat. Contr., Vol. 43, No. 1, pp. 120-125. · Zbl 0952.93106
[9] Glover S.F. (2003): Modeling and Stability Analysis of Power Electronics Based Systems. - Ph.D. thesis, Purdue University, USA.
[10] Jabbari F. (1997): Output feedback controllers for systems with structured uncertainty. - IEEE Trans. Automat. Contr., Vol. 42, No. 5, pp. 715-719. · Zbl 0886.93023
[11] Kanev S. (2004): Robust Fault-Tolerant Control. - Ph.D. thesis, University of Twente, the Netherlands.
[12] Maki M., Jiang J. and Hagino K. (2001): A stability guaranteed active fault-tolerant control system against actuator failures. - Proc. 40th IEEE Conf. Decision and Control, Orlando, FL, Vol. 2, pp. 1893-1898. · Zbl 1057.93018
[13] Noura H., Sauter D., Hamelin F. and Theilliol D. (2000): Faulttolerant control in dynamic systems: Application to a winding machine. - IEEE Contr. Syst. Mag., Vol. 20, No. 1, pp. 33-49.
[14] Patton R.J. (1997): Fault-tolerant control: The 1997 situation. - Proc. IFAC Symp. Safeprocess, Kingston Upon Hull, U.K, Vol. 2, pp. 1033-1055.
[15] Reberga L., Henrion D., Bernussou J. and Vary F. (2005): LPV modeling of a turbofan engine. - Proc. 16th IFAC World Congress, Prague, Czech Republic, (CD-ROOM).
[16] Rodrigues M. (2005): Diagnostic et commande active tolérante aux défauts appliqués aux systémes décrits par des multi-modčles linéaires. - Ph.D. thesis, Centre de Recherche en Automatique de Nancy, UHP, Nancy, France.
[17] Rodrigues M., Theilliol D., Adam-Medina M. and Sauter D. (2006): A fault detection and isolation scheme for industrial systems based on multiple operating models. - Contr. Eng. Pract.
[18] Rodrigues M., Theilliol D. and Sauter D. (2005a): Design of an active fault tolerant control and polytopic unknown input observer for systems described by a multi-model representation. - Proc. 44th IEEE Conf. Decision and Control and European Control Conference ECC, Seville, Spain, (CD-ROM).
[19] Rodrigues M., Theilliol D. and Sauter D. (2005b): Fault tolerant control design of nonlinear systems using LMI gain synthesis. - Proc. 16th IFAC World Congress, Prague, Czech Republic, (CD-ROM).
[20] Rosinova D. and Vesely V. (2004): Robust static output feedback for discrete time systems LMI approach. - Periodica Polytechnica, Vol. 48, No. 3-4, pp. 151-163.
[21] Shin J-Y. (2003): Parameter transient behavior analysis on fault tolerant control system. - Tech. Rep. NASA-CR-2003-212682-NIA, Report No. 2003-05, National Institute of Aerospace, Hampton, VA, USA.
[22] Da Silva S., Lopes Junior V. and Assuncao E. (2004): Robust control to parametric uncertainties in smart structures using linear matrix inequalities. - J. Braz. Soc. Mech. Sci. Eng., Vol. 26, No. 4, pp. 430-437.
[23] Theilliol D., Noura H. and Ponsart J.C. (2002): Fault diagnosis and accommodation of three-tank system bsaed on analytical redundancy. - ISA Trans., Vol. 41, No. 3, pp. 365-382.
[24] Theilliol D., Sauter D. and Ponsart J.C. (2003): A multiple model Based approach for Fault Tolerant Control in nonlinear systems. - Proc. IFAC Symp. Safeprocess, Washington D.C., (CD-ROM).
[25] Veillette R. (2002): Design of reliable control systems. - IEEE Trans. Automat. Contr., Vol. 37, pp. 290-304. · Zbl 0745.93025
[26] Wan Z. and Kothare M.V. (2004): Efficient scheduled stabilizing output feedback model predictive control for constrained nonlinear systems. - IEEE Trans. Automat. Contr., Vol. 49, No. 7, pp. 1172-1177. · Zbl 1365.93272
[27] Wu N.E., Zhang Y. and Zhou K. (2000): Detection, estimation and accommodation of loss of control effectiveness. - Int. J. Adapt. Contr. and Signal Process., Vol. 14, No. 7, pp. 775-795. · Zbl 1016.93025
[28] Zhang Y. and Jiang J. (2001): Integrated active fault-tolerant control using IMM approach. - IEEE Trans. Aerospace Electron. Syst., Vol. 37, No. 4, pp. 1221-1235.
[29] Zhang Y. and Jiang J. (2003): Bibliographical review on re-configurable fault-tolerant control systems. - Proc. IFAC Symp. Safeprocess, Washington, D.C., (CD-ROM).
[30] Zhang Y., Jiang J., Yang Z. and Hussain Z. (2005): Managing performance degradation in fault tolerant control systems. - Proc. 16th IFAC World Congress, Prague, Czech Republic, (CD-ROM).
This reference list is based on information provided by the publisher or from digital mathematics libraries. Its items are heuristically matched to zbMATH identifiers and may contain data conversion errors. In some cases that data have been complemented/enhanced by data from zbMATH Open. This attempts to reflect the references listed in the original paper as accurately as possible without claiming completeness or a perfect matching.